Toyotomi CTN/CTG-328W User Manual page 14

Press « + » or « - » button to adjust set temperature. Press «FAN» button to
adjust fan speed. Press «
NOTE
• For preventing cold air, after starting up heat mode, indoor unit will delay
1~5 minutes to blow air (Actual delay time depends on indoor ambient
temperature).
• Set temperature range from remote controller: 16~30℃ (61-86℉).
• Cooling only unit won't receive heat mode signal. If setting heat mode with
remote controller, press « ON/OFF « button can't start up the unit.
FAN
button
This button is used for setting Fan Speed in the sequence that goes from
AUTO, , , ,
Low speed Low-Medium speed
speed High speed
NOTE
• It's low fan speed under dry mode.
• Auto Clean (X-FAN) function: Hold fan speed button for 2s in cool or
dry mode, the icon « » is displayed and the in-door fan will continue
operation for a few minutes in order to dry the indoor unit even though you
have turned off the unit. After energization, Auto Clean (X-FAN) OFF is
defaulted. Auto Clean (X-FAN) is not available in auto, fan or heat mode.
This function indicates that moisture on evaporator of indoor unit will be
blowed after the unit is stopped to avoid mould.
Having set Auto Clean (X-FAN) function on: After turning off the unit by
pressing « ON/OFF « button indoor fan will continue running for a few
minutes. at low speed. In this period, Hold fan speed button for 2s to stop
indoor fan directly.
Having set Auto Clean (X-FAN) function off: After turning off the unit by
pressing «ON/OFF» button, the complete unit will be off directly.
/ » button to adjust fan blowing angle.
, , to
Auto
Turbo speed
14
then back to Auto.
Medium speed
Quiet speed
Medium-High
GB