Table of Contents
Advertisement
Eaton 91PS/93PS UPS 8–40 kW
Setting
Signal Input
Relay Outputs
Battery test
Bypass Limits
Screen Saver Time-
out
Meters
Lamp Test
HMI backlight
Control P/W level 1
Control P/W level 2
Reset statistics
Minimum required
kVa
7.2
If the level 1 password is enabled, you need to sign in.
1.
Press the lock icon in the top right corner of the screen.
2.
Type in your password and press OK.
You are signed in.
3.
Press Continue to return to the previous screen.
You have 3 attempts to type in the password. If an incorrect password is given
more than 3 times, you need to wait for 30 minutes before trying again.
To modify the user settings, you need to enter the level 2 password. For the
default passwords, see Section
7.3
7.3.1
The UPS system can consist of a single UPS or several parallel UPSs. UPSs
with their MOB open are not considered as part of the system.
To start the UPS system:
1.
Open the UPS front door.
2.
Check that the rectifier input switch S1 closed.
3.
Check that the battery breaker CB1 is closed.
4.
Close the UPS front door.
©
Eaton Corporation plc 2018. All rights reserved.
Description
Select signal input name and function or change contact polarity.
Configure the relay outputs.
Change the power level and duration for battery test.
Change the bypass voltage or bypass frequency.
Change the screen saver timeout.
Change the meters format.
Enable the lamp test.
Adjust the backlight brightness.
Change the level 1 password, or remove the password on level 1.
The default value is 1111.
Change the level 2 password. The default value is 0101.
Reset all statistics.
Change the minimum required kVa.
Signing in
System control instructions
Starting the UPS system in the double conversion mode
7.1.4.1
.
Revision: 005
Document ID: P-164000493
User's and installation guide
88 (117)
Advertisement
Table of Contents
