Front Axle - Toro Groundsmaster 3280-D Service Manual

Front Axle

RIGHT
FRONT
11
12
13
1. Cap screw
2. Cap screw (3 used)
3. Lock washer (4 used)
4. Flat washer
5. Spacer
6. Mounting spacer (4 used)
7. Pinion Gear
8. Snap ring
9. Gasket
Removal (Fig. 19)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Remove the cutting deck (or implement) (See Cut-
ting Unit Operator's Manual).
Drive Axles
26
27
8
9
10
14
Figure 19
10. Front axle assembly
11. Jam nut
12. Transmission anchor
13. Lock nut
14. Carrier bracket (2 used)
15. Lug nut (5 used per wheel)
16. Tire and wheel assembly
17. Cap screw (4 used)
18. Flat washer (4 used)
Page 8 − 14
25
24
23
4
3
7
5
6
19
20
18
17
19. Axle shim (as needed)
20. Hydraulic fitting
21. Hose clamp
22. Hydraulic hose
23. Transmission
24. Lock nut (4 used)
25. Cap screw
26. Socket head screw (4 used)
27. Lock washer (4 used)
3. To prevent contamination of the hydraulic system,
thoroughly clean transmission and front axle.
4. Drain oil from front axle (see Traction Unit Operator's
Manual).
5. Loosen hose clamp (item 21) and pull hydraulic hose
(item 22) from fitting (item 20) on axle.
1
2
3
75 to 80 ft−lb
(102 to 108 N−m)
22
21
16
15
Groundsmaster 3280−D/3320