Oil Cooler (Groundsmaster 3280--D) - Toro Groundsmaster 3280-D Service Manual

Oil Cooler (Groundsmaster 3280- -D)
RIGHT
FRONT
1. Radiator
2. Lock washer
3. Hex nut
4. Oil cooler
Removal (Fig. 47)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Open hood (see Traction Unit Operator's Manual).
Remove the radiator screen.
3. Loosen and remove hydraulic hoses from oil cooler.
Remove and discard o--rings. Allow hoses to drain oil
into a suitable container.
4. Remove hex nuts and lock washers that secure oil
cooler to radiator.
5. Pull oil cooler from radiator.
Hydraulic System
4
5
9
10
5. O- -ring
6. Hydraulic hose
7. Hydraulic hose
8. Flange head screw
3
2
2
6
3
5
7
8
Figure 47
Installation (Fig. 47)
1. Position and secure oil cooler to radiator with lock
washers and hex nuts.
2. Coat new o--rings with hydraulic oil and position o--
rings to hydraulic hose ends. Install hydraulic hoses to
oil cooler.
3. Install radiator screen and close hood.
4. Check hydraulic fluid level in reservoir (front axle)
and adjust as required (see Traction Unit Operator's
Manual).
Rev. A
Page 5 - - 60
1
11
9. Radiator support
10. Flange nut
11. Radiator shield
Groundsmaster 3280--D/3320