Toro Groundsmaster 3280-D Service Manual page 155

Removal (Fig. 8)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Disconnect electrical connector from the seat switch.
On pneumatic seat suspension systems, disconnect
electrical connector from the suspension.
3. Remove two (2) flange head screws (item 8) and two
(2) flange nuts (item 6) that secure seat base to ma-
chine.
4. Remove seat and seat base from machine.
5. Remove seat components as necessary using Fig-
ure 8 as a guide.
Groundsmaster 3280−D/3320
Installation (Fig. 8)
1. Install seat components using Figure 8 as a guide.
2. Position seat and seat base to machine.
3. Secure seat base to machine with two (2) flange
head screws (item 8) and two (2) flange nuts (item 6).
4. Connect electrical connector to the seat switch. On
pneumatic seat suspension systems, connect electrical
connector to the suspension.
Page 7 − 17 Chassis