P.t.o. Shaft - Toro Groundsmaster 3280-D Service Manual

P.T.O. Shaft

RIGHT
FRONT
6
8
9
10
ANTISEIZE
LUBRICANT
1. Cap screw
2. P.T.O. drive belt
3. Woodruff key
4. Cap screw (4 used)
5. Lock washer (4 used)
6. Washer (4 used)
7. Rubber mount (2 used)
WARNING
Do not start the engine and engage the P.T.O.
switch when the P.T.O. drive shaft is discon-
nected from the cutting deck (or implement). If
the engine is started and the P.T.O. shaft is al-
lowed to rotate, serious injury could result.
Disconnect the P.T.O. electric clutch electrical
connector whenever the P.T.O. drive shaft is
disconnected from the cutting deck (or imple-
ment).
P.T.O. System
6
7
13
12
11
8. Cap screw (2 used)
9. Flange bearing
10. Grease fitting
11. Hex nut
12. Bushing support plate
13. Carriage screw
14. P.T.O. bearing bracket
ANTISEIZE
LUBRICANT
3
4
5
16
15
14
Figure 5
Removal (Fig. 5)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine, engage parking brake and
remove key from the ignition switch.
2. Remove P.T.O. drive shaft from machine (see P.T.O.
Drive Shaft Removal in this section).
3. Remove P.T.O. drive belt from machine (see Traction
Unit Operator's Manual).
4. Remove rear frame and axle assembly from ma-
chine (see Rear Frame and Axle Assembly Removal in
the Service and Repairs section of Chapter 7 − Chas-
sis).
Page 9 − 8
LOCTITE #242
2
18
13
17
9
11
21
15. Lock nut (2 used)
16. P.T.O. shaft
17. P.T.O. tension shaft
18. P.T.O. pulley
19. Flat washer
20. Lock washer
21. P.T.O. drive shaft
Groundsmaster 3280−D/3320
1
20
19