Toro Groundsmaster 3280-D Service Manual page 30

15.Disconnect wire harness connectors from the follow-
ing engine components:
NOTE: Label all electrical leads for reassembly pur-
poses.
A. Alternator connector and stud.
B. High temperature shut down switch and temper-
ature sender located on the water pump housing.
C. Fuel solenoid on carburetor.
D. Oil pressure switch located near the engine oil
dipstick.
E. Ignition coils located on the right side of the en-
gine.
F. Connector, fusible link connector and positive
battery cable from the starter motor.
G. Wire harness ground wire from the muffler brack-
et.
H. P.T.O. clutch wire connector.
I. Crank position wire connector.
16.Remove engine from machine:
A. Attach short section of chain between lift tabs lo-
cated on each end of the cylinder head.
B. Connect a hoist or chain fall at the center of the
short section of chain. Apply enough tension on the
short chain so that the engine will be supported.
C. Remove fasteners that secure the engine (with
brackets) to the engine shock mounts and engine
mount brackets.
CAUTION
One person should operate lift or hoist while the
other person guides the engine out of the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while removing the engine.
D. Raise engine and remove from machine.
17.If necessary, remove engine brackets from engine
(Fig. 15).
Gasoline Engine
6
3
4
3
7
1. Gasoline engine
2. Engine bracket
3. Flat washer
4. Cap screw
Installation (Fig. 11)
1. Locate machine on a level surface with cutting deck
(or implement) lowered and key removed from the igni-
tion switch. Chock wheels to keep the machine from
moving.
2. Make sure that all parts removed from the engine
during maintenance or rebuilding are reinstalled to the
engine.
3. If engine brackets were removed from the engine,
reinstall them to engine (Fig. 15).
4. If engine mount brackets (items 20 and 28) were re-
moved from frame, secure them to frame with cap
screws and lock washers. Torque screws from 50 to 60
ft−lb (68 to 81 N−m).
IMPORTANT: The left, rear shock mount (item 15) is
different than the other three mounts (item 19). If
shock mounts were removed from engine mount
brackets on frame, make sure that shock mount
with red patch is correctly installed at left, rear posi-
tion.
5. Position fan shroud around the engine fan.
6. Reinstall engine to machine.
A. Attach short section of chain between lift tabs lo-
cated on each end of the cylinder head
B. Connect a hoist or chain fall at the center of the
short section of chain. Apply enough tension on the
short chain so that the engine can be supported.
Page 3 − 14
5
3
2
1
Figure 15
5. Pivot plate
6. Engine bracket
7. Engine bracket
Groundsmaster 3320
4
3
4