Toro Groundsmaster 3280-D Service Manual page 82

8. Slide traction rod (item 50) to pump lever and secure
with flat washer (item 20) and cotter pin (item 19).
9. Check transmission drive shaft alignment and adjust
if necessary (see Transmission Drive Shaft in this sec-
tion). Install transmission drive shaft.
10.On 4 wheel drive machines, connect 4WD driveshaft
to transmission (see Rear Axle Drive Shaft (4 Wheel
Drive) Installation in the Service and Repairs section of
Chapter 8 -- Drive Axles).
Hydraulic System
11. Install hydraulic hoses to fittings on transmission in
positions noted during disassembly.
12.Check hydraulic fluid level in reservoir (front axle)
and adjust as required (see Traction Unit Operator's
Manual).
13.Follow Hydraulic System Start--up procedures.
14.Check traction drive for neutral and neutral switch
adjustment (see Traction Unit Operator's Manual).
Page 5 - - 36 Groundsmaster 3280--D/3320