Toro Groundsmaster 3280-D Service Manual page 169

CAUTION
Be careful when removing adjuster and brake re-
turn springs. The springs are under tension and
could possibly slip during removal.
7. Remove adjuster spring (item 13).
8. Spread the upper ends of the brake shoes and re-
move star wheel assembly (items 4, 5 and 6).
9. Remove brake lever retainers (cotter pins) (item 12).
10.Pull brake lever from brake shoes.
11. Remove brake shoe return springs (Items 7 and 11)
by prying the end of the spring up and out of the brake
shoe. Use a brake spring pliers or flat blade screwdriver.
12.Remove brake shoes by sliding them both down
from brake spider.
Assembly
1. Slide brake shoes up onto brake spider.
CAUTION
Be careful when installing brake return and ad-
juster springs. The springs are under tension
and could possibly slip during installation.
Groundsmaster 3280−D/3320
2. Position brake return springs (Items 7 and 11) to
brake shoes.
3. Position brake lever to brake shoes. Secure brake le-
ver to shoes with retainers (item 12).
4. Spread the upper ends of the brake shoes and install
star wheel assembly (items 4, 5 and 6).
5. Install adjuster spring (item 13).
6. Install brake drum on wheel studs. Install lock nut
(item 1).
7. Install wheel assembly on studs and secure with five
(5) lug nuts. Torque lug nuts in a crossing pattern from
75 to 80 ft-lb (102 to 108 N−m).
8. Secure brake cable to brake lever with clevis pin
(item 10) and cotter pin (item 11). Attach brake return
spring (item 12) to brake cable link (item 13).
9. Remove jack stands or blocking and lower machine
to the floor.
10.Adjust brakes (see Traction Unit Operator's Manu-
al).
Page 8 − 7 Drive Axles