Toro Groundsmaster 3280-D Service Manual page 31

CAUTION
One person should operate lift or hoist while the
other person guides the engine into the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while installing the engine.
C. Lower engine to the machine frame. Make sure
that the engine bracket holes are aligned with the
holes in the engine shock mounts.
D. Secure engine to the engine mounts.
7. Install clevis pin and cotter pin to secure hood cable
to muffler bracket.
8. Connect transmission drive shaft to engine pulley
(see Hydraulic Transmission Drive Shaft Installation in
the Service and Repairs section of Chapter 5 − Hydrau-
lic System).
9. Reconnect all wire harness connectors to engine
components.
10.Remove plugs installed in hoses during disassem-
bly. Connect hoses to the engine.
A. Connect fuel hose to the carburetor inlet fitting.
Secure with hose clamp.
B. Connect upper and lower radiator hoses to the
engine. Secure with hose clamps.
11. Position throttle and choke cables to engine gover-
nor levers (Fig. 14). Secure cables to governor bracket
with cable clamp and screw. Adjust cables (see Adjust
Throttle Control and Adjust Choke Control in the Adjust-
ments section of this chapter).
Groundsmaster 3320
12.Install air cleaner (see Air Cleaner Installation in this
section).
IMPORTANT: Make sure that clutch pulley and
P.T.O. pulley are aligned during P.T.O. shaft installa-
tion.
13.Install P.T.O. shaft to machine (see P.T.O. Shaft
Installation in Service and Repairs section of Chapter 9
− P.T.O. System).
14.Position fan shroud to radiator. Make sure that a
minimum of .250" (6.4 mm) clearance exists at all points
between shroud and fan. Secure fan shroud to radiator
with four (4) cap screws, flat washers and lock nuts.
15.Install coolant reservoir to bracket on radiator fan
shroud (Fig. 13). Install overflow hose to radiator fill
opening and secure with hose clamp.
16.Add coolant to radiator (see Traction Unit Operator's
Manual).
NOTE: Make sure to attach negative battery cable as
battery base is installed.
17.Position battery base to brackets and secure with
cap screws and flange nuts (Fig. 12).
18.Install battery to machine (see Battery Service in the
Service and Repairs section of Chapter 6 − Electrical
System).
19.Check engine oil level (see Traction Unit Operator's
Manual).
20.Connect positive (+) and then negative (−) battery
cables to the battery.
21.Close hood (see Traction Unit Operator's Manual).
Page 3 − 15 Gasoline Engine