Disassembly (Fig. 12)
1. Disassemble castor forks and wheels as required
using Figure 12 as a guide.
Assembly (Fig. 12)
1. Assemble castor forks and wheels using Figure 12
as a guide. Make sure that thrust washers (item 15) are
positioned directly above and below castor arm bush-
ings.
Groundsmaster 3280−D/3320
2. If bearings were removed from wheel hub:
A. Press first bearing into hub until it contacts shoul-
der of hub.
B. Place inner bearing spacer in hub and then press
second bearing into hub.
C. Check that spacer fits tightly between bearings
after hub assembly.
3. If castor fork was removed from castor arm, lubricate
grease fitting.
4. See Cutting Unit Operator's Manual for castor wheel
adjustment.
Page 10 − 15
Cutting Units