Toro Groundsmaster 3280-D Service Manual page 43

Removal (Fig. 8)
1. Park machine on a level surface, lower cutting deck
(or implement), stop engine and remove key from the
ignition switch. Chock wheels to keep the machine from
moving.
2. Open hood (see Traction Unit Operator's Manual).
3. Disconnect negative (−) and then positive (+) battery
cables at the battery.
4. Remove battery from machine (see Battery Service
in the Service and Repairs section of Chapter 6 − Electri-
cal System).
5. Remove cap screws and flange nuts that secure bat-
tery base to brackets. Remove battery base from ma-
chine.
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene−glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
6. Drain coolant from radiator (see Traction Unit Opera-
tor's Manual).
7. Loosen hose clamp and remove overflow hose from
radiator fill opening (Fig. 9). Remove coolant reservoir
from radiator fan shroud.
8. Remove four (4) cap screws, flat washers and lock
nuts that secure fan shroud to radiator (Fig. 9). Position
fan shroud away from the radiator.
9. Remove P.T.O. shaft from machine (see P.T.O. Shaft
Removal in Service and Repairs section of Chapter 9 −
P.T.O. System).
10.Remove air cleaner (see Air Cleaner Removal in this
section).
11. Remove throttle cable from injector pump (Fig. 10):
A. Remove retaining ring that secures throttle cable
end to injector pump control arm.
B. Loosen throttle cable clamp and remove throttle
cable from the injector pump.
C. Position throttle cable away from the engine.
Groundsmaster 3280−D
3
2
4
5
1. Radiator
2. Hose clamp
3. Overflow hose
4. Flat washer
1
1. Cable end
1. Fuel return hose
Page 4 − 11
4
6
7 4
6
5
8
1
Figure 9
5. Lock nut
6. Cap screw
7. Coolant reservoir
8. Fan shroud
2
Figure 10
2. Cable clamp
2
1
Figure 11
2. Fuel supply hose
Diesel Engine