Hood Installation; Maintenance And Cleaning - Kernau KBH 07602 X Manual Instruction

CAUTION!
Before reconnection the hood circiut to the power supply and checking if works correctly,
should always make sure if the cord is properly mounted. The hood is equipped with special
power cord. In case of damage this power cord, please order it in service center.
The minimum distance between the surface on which the dishes on the heating device
are located and the lowest part of the kitchen hood should be not less than 45cm in the case of
electric cookers and not less than 65cm in the case of gas or electric-gas cookres. If the heating
appliance manual instruction indicates a grater installation distance for the kitchen hood,
please follow these indications.
The hood should be installed in the following order:
1. Prepare the cabinet for mounting the hood:
- for cabinets with a width of 596mm "60", remove the bottom of the cabinet.
- for cabinets with a width of> 596mm, cut a hole in accordance with Figure S3.
2. Remove the aluminum grease filter figure S1.
3. Carefully slide the hood into the previously prepared cabinet, hold the hood with one hand
or ask an additional person for help. Screw in the screws by selecting one mounting option:
A-fixing to the cabinet side walls, B-fixing to the top of the cabinet.
4. Install the aluminum grease filter previously removed.
Before undertaking any operations related to the maintenance of the device, disconnect
the hood from the power supply network. The device should be washed with specialized agents
for surfaces made of stainless steel. The hood should be cleaned with mild agents, do not use
abrasives. Regular maintenance will improve the operation of the hood.
DO NOT USE ALCOHOL !
CAUTION!
Failure to comply with the regulations regarding cleaning of the device and replecement of
filters creates the risk of fire. It is therefore recommended to follow the given instructions.
The manufacturer is not responsible for any damage to the engine or fires resulting from non-
compliance with the maintenance rules and the instructions mentioned above.
Hood instalation

Maintenance and cleaning

15