Purpose And Type Of Work; Power Connection; Hood Installation - Kernau KBH 07601 X Manual Instruction

31. This appliance should be installed at the minium distance 450mm from electric kitchen
hob and 650mm from gas cooker.
32. Meals prepared with fats should stay under the supervision, overheated fat may catch
fire.
33. When connecting to a 220V network, it is required to connect to a good electrical
outlet.
34. This appliance is not intended to use by persons (including childrens) with limited
physical, sensory or mental ability or by people whitout experience or knowledge of
the equipment, unless it is done under the supervision or in accordance with the
instructions provide by those responsible for their safety.
CAUTION !
The device is wrapped in foil, which may cause a danger situation. To avoid the risk of an
accident, keep the foil away from childern. Also do not allow children to play nearby or use
the hood.
This hood is intended to work in suction mode witch the dischrage the vapors to the
outside or to work in filtering mode with internal recirculation, closed circuit.
The mains voltage should comply with the conditions specified on the rating plate
located inside the hood. If the hood is equipped with plug, it should be placed in a socket that
meets the reqirements of applicable regulations and located in easily accessible place. If the
hood is not equipped with plug, instalation of the hood entrust to the qualificated technician.
CAUTION!
Before reconnection the hood circiut to the power supply and checking if works correctly,
should always make sure if the cord is properly mounted. The hood is equipped with special
power cord. In case of damage this power cord, please order it in service center.
The minimum distance between the surface on which the dishes on the heating device
are located and the lowest part of the kitchen hood should be not less tha 45cm in the case

Purpose and type of work

Power connection

Hood instalation
15