EN
21
PUROPSE AND TYPE OF WORK
This hood is intended to work in suction mode witch the dischrage the vapors
to the outside or to work in filtering mode with internal recirculation, closed
circuit.
POWER CONNECTION
The mains voltage should comply with the conditions specified on the rating
plate locateg inside the hood. If the hood is equipped with plug, it should
be placed in a socket that meets the reqirements of applicable regulations
and located in easily accessible place. If the hood is not equipped with plug,
instalation of the hood entrust to the qualificated technician.
CAUTION:
Before reconnection the hood circiut to the power supply and checking
if works correctly, should always make sure if the cord is properly mounted.
The hood is equipped with special power cord. In case of damage this
power cord, please order it in service center.
HOOD INSTALATION
The minimum distance between the surface on which the dishes on the heating
device are located and the lowest part of the kitchen hood should be not less
tha 45cm in the case of electric cookers and not less than 65cm in the case
of gas or electric-gas cookres. If teh heating appliance manual instruction
indicates a grater insteallation distance for th kitchen hood, please follow
these indications. Installation of the hood and hood casing pipes shown in
figure S3. When installing the hood, obey the general regulations regarding
the discharge of air from the room. It should be taken into account that the
use of spiral aluminium pipes limits the hood's efficiency and increases the
volume of air flowing.