Purpose And Type Of Work; Power Connection - Kernau KBH 07602 X Manual Instruction

17. All assembly and maintenance operations should be carried out using protective gloves.
18. Before connecting the hood to the mains power supply and checking its proper
operation, always check that the power cable has been correctly installed and that it has
not been crushed by the hood during installation.
19. Never use the hood without properly installed filters.
20. To the range necessary for the application of technical and safety measures regarding
the discharge of flue gases, the regulations issued by the competent local authorities
must be strictly observed.
21. The kitchen hood should be cleaned inside and outside (min once at month, according
with maintenance tips given in these manual), overheated fat is flammable.
22. Under the kitchen hood do not leave the open fire. Set the minimum flame when
removing dishes from the burner.
23. The use of open fire is dangerous to filters and creates the risk of fire, so do not under
any circumstances. When frying, be careful not to overheat the oil so that it does not
ignite. Available parts can become very hot if used together with cooking applainces.
24. Damaged the power cord should be replaced with special cord avaiable at manufacter
or specialist repair shop.
25. The vapors cannot be discharged in the chimney duct used to remove flue gas from
appliances burning gas or other fules ( do not apply to closed circulation).
26. If the cleaning process is not carried out according to the instructions, there is a risk of
fire.
27. To aviod electric shock, do not use or leave the hood without correctly installed
lightbulbs.
CAUTION !
The device is wrapped in foil, which may cause a danger situation. To avoid the risk of
an accident, keep the foil away from childern. Also do not allow children to play nearby
or use the hood.
This hood is intended to work in suction mode witch the dischrage the vapors to the
outside or to work in filtering mode with internal recirculation, closed circuit.
The mains voltage should comply with the conditions specified on the rating plate
located inside the hood. If the hood is equipped with plug, it should be placed in a socket that
meets the reqirements of applicable regulations and located in easily accessible place. If the
hood is not equipped with plug, instalation of the hood entrust to the qualificated technician.

Purpose and type of work

Power connection

14