Omron SYSMAC CS1W-LCB01 Operation Manual page 60

Outline
Category Type
Operation Alarm/ 111
Block Signal (See note
1.)
restric-
112
tions/Hold
(See note
1.)
113
(See note
1.)
115
(See note
1.)
116
(See note
1.)
118
(See note
1.)
Arithmetic 121
(See note
1.)
122
(See note
1.)
123
(See note
1.)
126
(See note
1.)
127
(See note
1.)
Functions 131
(See note
1.)
132
(See note
1.)
133
(See note
1.)
134
(See note
1.)
135
(See note
1.)
136
(See note
1.)
26
Block Block Name
Model
High/Low Alarm Provides the alarm contact outputs for the
Deviation Alarm Provides the alarm contact outputs for the
Rate-of-change
Operation and
Alarm
High/Low Limit
Deviation Limit
Analog Signal
Hold
Addition or Sub-
traction
Multiplication
Division
Arithmetic Oper-
ation
Range Conver-
sion
Square Root
Absolute Value
Non-linear Gain
(Dead Band)
Low-end Cutout Sets output to zero close to the zero point
Segment Lin-
earizer
Temperature
And Pressure
Correction
Function
high and low limits of single analog signals.
deviation of two analog signals.
Provides the alarm contact outputs for the
high and low limits of rate-of-change opera-
tion when the analog signal rate-of-change
is output.
Limits the high and low limits of single ana-
log signals.
Calculates the deviation between two ana-
log signals, and limits the deviation within
that range.
Holds the maximum, minimum or instanta-
neous value of single analog signals.
Performs addition/subtraction with gain and
bias on up to 4 analog signals.
Performs multiplication with gain and bias
on up to 2 analog signals.
Performs division with gain and bias on up
to 2 analog signals.
Performs various math operation (trigono-
metric. logarithmic, etc.) on floating-point
decimal values converted (to industrial
units) from up to 8 analog inputs.
Easily converts up to 8 analog signals sim-
ply by inputting the 0% and 100% input val-
ues and 0% and 100% output values.
Performs square root extraction (with low-
end cutout) on single analog signals.
Performs non-linear (3 gain values) opera-
tion on single analog signals. Analog sig-
nals can also set as a dead band (with
different gap).
Outputs the absolute value of single analog
signals
of single analog signals.
Converts single analog signals to 15 seg-
ments before the signals is output.
Performs temperature and pressure correc-
tion.
Section 1-1
Allocatable Block
Address
LCB05/05D: 001 to 500
LCB03: 001 to 300
LCB01: 001 to 050
LCB05/05D: 001 to 100
LCB03: 001 to 300
LCB01: 001 to 050
LCB05/05D: 001 to 500
LCB03: 001 to 300
LCB01: 001 to 050