Omron SYSMAC CS1W-LCB01 Operation Manual page 104

Basic Procedure for Using the Loop Controller
6. Actual Operation
1,2,3...
70
CPU Unit
Loop Control Board
1. Tune the Loop Controller using the CX-Process Tool or SCADA software.
(For example, change the settings and PID constants.)
Refer to the CX-Process Tool Operation Manual.
2. Monitor PV and alarms on CX-Process Tool or SCADA software.
Refer to the CX-Process Tool Operation Manual.
Peripheral port or RS-232C port
Run status
Run operation
Section 1-5
Set the Set Point and PID
constants, and monitor
PV and other settings on
CX-Process Monitor
running on the computer.