Omron SYSMAC CS1W-LCB01 Operation Manual page 173

Exchanging Data with the CPU Unit
Example 1:
Example 2:
Auxiliary Area Flags Relevant to the Loop Controller
Flags (Loop Controller to CPU Unit)
Word Bit Name
A324 06 Right-side Inner
Board Nonfatal
Error Flag (Pro-
cess-control
CPU Unit
(CS1D-
CPU@@P) only)
07 Left-side Inner
Board Nonfatal
Error Flag (Pro-
cess-control
CPU Unit
(CS1D-
CPU@@P) only)
To perform processing when the Loop Controller has stopped running
Execution of a specific process is enabled as follows when the Loop Control-
ler has stopped running or a data exchange error has occurred with the CPU
Unit functioning as a Inner Board:
Run Status Flag
A35811
To notify that function blocks have changed while the Loop Controller was run-
ning.
If a function block is changed from the CX-Process Tool during Loop Control-
ler operation, notification is made by creating a warning or other indication of
the change.
Function Block
Changed Flag
A35815
Explanation
This flag is set to 1 (ON) when the right-side Inner Board
has a nonfatal error when the CS1D CPU Unit is in duplex
mode.
This flag is set to 1 (ON) when the left-side Inner Board has
a nonfatal error when the CS1D CPU Unit is in duplex
mode.
Section 3-3
Processing at
stoppage of Loop
Controller
Notification
processing for
function block
change
Settings
1: Nonfatal error
0: No nonfatal error
1: Nonfatal error
0: No nonfatal error
139