Nortel Communication Server 1000 Manual page 43

Prompt Response
CEQU YES
.......
0-159
DDCS
LD 17 Configure DASS2 DCHI and PRI loop number (if NT5K75 or NT6D11AE DCHI is used
in expanded mode)
Prompt Response
REQ CHG
TYPE CFN
.......
PARM YES
.......
35-1000
DTIB
4-100
DTOB
.......
CEQU YES
.......
DDCS 0-159
LD 17 Configure DASS2 DCHI and PRI loop number.
Prompt Response
REQ CHG
TYPE CFN
ADAN 0-63
CTYP DCHI
DNUM 0-15
Copyright © 2007, Nortel Networks
.
Description
To allow changes to the Common Equipment parameters.
The PRI loop number for the new DASS2 link. Enter multiples
separated with a space.
Note: PRI loop numbers may have to be even values if the
adjacent loop on the network card is programmed.
Description
Modify existing data base.
Configuration data block.
To allow changes to the system buffers.
To define the number of trunk input buffers for the entire system.
To define the number of trunk output buffers per DCHI.
To allow changes to the Common Equipment parameters.
The PRI loop number for the new DASS2 link. Enter multiples
separated with a space.
Note: PRI loop numbers may have to be even values if the
adjacent loop on the network card is programmed.
Description
Modify existing data base.
Configuration data block.
The DASS2 D-channel port number. This is a logical port
number, independent of the hardware I/O addresses. This
number is used to reference the D-channel in LD 74.
Selects the card type as being DCHI.
The hardware I/O address of the DCHI. The switches on the
DCHI must be set to correspond to this address.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 02.01 Standard
Release 5.5 7 December 2007
Configuring basic capabilities 43