Nortel Communication Server 1000 Manual page 179

Code Description
DTM335 n mi DTSL/DDSL n has failed to a message
sent to it; mi is the message indicator
code for the message
DTM336 n mi An attempt to send a message to
DTSL/DDSL n has failed; mi is the
message indicator code for the
message. Note: a spurious DTM335
is likely to follow
DTM337 n li mi Invalid input from DTSL/DDSL n; l is
the length indicator, mi is the message
indicator code for the message
DTM338 n DTSL/DDSL n cannot be disabled
because the DTCS/DDCS is disabled
DTM339 n x Five minutes have elapsed since
DTSL/DDSL n was started and placed
in the active state; some channel
reset acknowledgements have bee
received, but "x" channels fail to start
DTM340 n Although DTSL/DDSL n is active
according to level 3, a report has been
received from level 2 indicating the link
is idle
DTM341 n Although DTSL/DDSL n is idle
according to level 3, a report has been
received from level 2 indicating the link
is starting or active
DTM342 n c p Level 2 has detected a discrepancy in
the configuration of real channel c on
DTSL/DDSL n when a message was
sent from level 3; "p" indicates one of
the following problems:
0 — channel number out of range
1 — channel not configured
4 — channel not active
5 — li is incorrect
6 — already configured
7 — mi is out of range
Copyright © 2007, Nortel Networks
.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 02.01 Standard
Release 5.5 7 December 2007
Diagnostic error messages 179
Action
If issued after a command has been
entered, then repeat the command; If
error continues, suspect a faulty DCHI
DTCS(s) must be enabled first.
If fault persists, suspect a faulty DCHI.
If fault persists, suspect a faulty DCHI.
Check the state and configuration of
the channel.