Nortel Communication Server 1000 Manual page 143

Table 52
Steps for installing the NT8D72 PRI card
Step Action
1 Determine the cabinet and shelf location of the circuit card to be installed; please refer
to "PRI circuit card locations" (page 141)
2 Unpack and inspect circuit cards.
3
Set the option switch on the PRI circuit card to the 75/120 ohm position.
4
Install PRI circuit card in the assigned shelf and slot.
5
Install Network circuit card (if no Network loop connection is available).
6
If required, install I/O adapters in I/O panel.
7
Run and connect the PRI cables.
8 If required, install connecting blocks at MDF or wall mounted cross-connect terminal.
9 If required, designate connecting blocks at MDF or wall mounted cross-connect
terminal.
10
If required, install Network Channel Terminating Equipment (NCTE).
11
Cross-connect PRI circuits.
12 Add related office data into switch memory.
13
Run IDA status check. Refer to the DASS2 (NN43001-571) for the IDA verification
tests, IDA status check, and IDA startup test.
Installing a system network expansion shelf
The procedure in
(page 143)
"Integrated Digital Access (IDA) equipment" (page 75)
representation of a Meridian 1 network expansion shelf"
Table 53
Steps for installing a network expansion shelf
Action
Step
1
Determine the cabinet and shelf location of the Network shelf to be installed.
2 Unpack and inspect the shelf.
3 Remove the existing left or right rear Intelligent Peripheral Equipment (IPE) shelf
(if required).
Copyright © 2007, Nortel Networks
.
Table 53 "Steps for installing a network expansion shelf"
is used schematic representation of a network expansion shelf.
CAUTION
Service Interruption
Do not place the circuit cards in the shelf until Step 7 is completed.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 02.01 Standard
Release 5.5 7 December 2007
which immediately precedes this section.
for a schematic
Non DPRI 143