Table of Contents
Advertisement
Electronic convection oven rev. .4___________________________________MODD. EKF 611 CTC – EKF 1011 CTC
3.7 Electrical connection
Connection to the power mains must be performed according to regulations in force. Before
performing the connection ensure that:
-
the voltage and frequency of the power supply system match with
the specifications on the "technical data" plate affixed on the side of the appliance;
-
the limiting valve and the system are able to withstand the appliance's load (see "technical data"
plate);
-
the power supply system is fitted with effective earthing connection according to the regulations
in force;
-
In the permanent connection to the mains, a protective pole switch must be provided between
the appliance and the mains with minimum opening between the contacts of overvoltage
category III (4000V), sized for the load and complying with applicable regulations (e.g. automatic
magnetic circuit breaker);
-
the pole switch used for the connection is easily accessible with installed appliance;
-
the yellow/green earthing cable is not interrupted by the switch;
-
The appliance must be connected to an equipotential system the effectiveness of which must be
suitably assessed according to applicable regulations. This connection must be performed with
the suitable terminal located on the rear and marked with the symbol
conductor must have minimum section 2.5mm².
-
when the appliance is operating, the power supply voltage does not deviate from the nominal
voltage value by ±10%;
-
ensure the power supply cable does not enter in contact with the appliance's hot parts after
inserting it in the terminal board.
-
if the power supply cable is damaged it must be replaced by the manufacturer or their technical
support service, or in any case by a person with similar qualifications, to prevent any risk.
_________________________________________________________________________________________ page 9
. The equipotential
Advertisement
Table of Contents
