Table of Contents
Advertisement
Electronic convection oven rev. .4___________________________________MODD. EKF 611 CTC – EKF 1011 CTC
Touch key "STEP"
to select the TIME parameter
then touch keys
and
to set the
desired value.
As soon as the TIME parameter is set, the background of the OVERVIEW SCREEN turns blue to
indicate that STEP 2 has become operative. Complete setting the values of the other desired
parameters. To move to the following steps (STEP 3, STEP 4 ...) repeat the same operations
described for STEP 2.
Upon completing step setting, start the cooking cycle with the "START/STOP"
key.
The display shows the OVERVIEW SCREEN of STEP 1 of the cooking cycle and the overall number
of steps it consists of. (E.g. 1/5 means that STEP 1 of the total 5 set is active).
Next to the TIME parameter: the "count-down" of the active step is shown on the left and the
overall time of all cooking cycle steps is shown on the right.
In the event of "manual" baking the display shows the word "MANUAL", in case of
"programmed" baking, the name of the stored recipe (program) is displayed.
4.3.5 Starting/stopping the cooking cycle
Once the desired cooking parameters are set, to start the cycle touch the "START/ STOP"
key.
To stop the cooking cycle at any time touch the "START/ STOP"
key again for a few
seconds.
When a cooking cycle is completed ( in "manual" mode or in "programmed" mode) a buzzer
goes off ("beep") for 30'' and at the same time the words flash on the screen : "COOKING
COMPLETED".
If during this period the
key is activated, the OVERVIEW SCREEN
of the cooking cycle just ended is displayed again. The cooking cycle is automatically reactivated
for 1 MINUTE. To lengthen the cooking time just touch the "STEP"
key and select the TIME
parameter
; then touch the key
to set the desired value.
The 30'' "cooking completed" buzzer may be interrupted at any time by touching the "STEP" key
or the "START/STOP"
key.
The OVERVIEW SCREEN of the cooking cycle just ended is displayed again.
4.3.6 Cooking cycle setting
4.3.6.1 Cooking cycle with time and temperature in chamber
From "TIME" PARAMETER SCREEN
Use the keys
and
to set the desired value:
TIME ("INF" or between 0h 01' and 9h 59')
Touch the "STEP"
key to set the desired option:
PAUSE (from 0h 01' to 23h 59)
MAINTENANCE ("ON" or "OFF")
Touch the "SELECT"
key to confirm the set values.
From OVERVIEW SCREEN
_________________________________________________________________________________________ page 21
Advertisement
Table of Contents
