eka EKF 611 CTC Original Operating And Instruction Manual page 12

TECNOEKA Srl ___________________________________________________________ operating and instruction manual
3.8 Power supply cable connection
Remove the back and left side of the appliance to access the power supply terminal board.
Loosen the cable retainer at the rear (bottom) of the appliance (see Fig.1) and run the cable
through it until reaching the terminal board. Prepare conductors for connection with the terminal
board so that the earth conductor is the last to be extracted from its terminal in the event the
cable should be abnormally pulled.
Only for EKF 611 CTC – EKF 611 CTC/0/037 – EKF 1011 CTC
Connect the 3 phase conductors (L1, L2, L3) of the cable to the terminals marked with
"1"(brown conductor) "2"(black conductor) and "3"(grey conductor) of the terminal board, the
neutral conductor (blue) to the terminal marked with "4" or "5" and the earth conductor
(yellow/green) to the terminal marked with the symbol (see diagram also available by the
terminal board):
For EKF611CTC/0/037 For EKF611CTC-EKF1011CTC
Only for EKF 611 CTC/0/048
Connect the 3 phase conductors (L1, L2, L3) of the cable to the terminals marked with
"1"(brown conductor) "2"(black conductor) and "3"(grey conductor) of the terminal board, and
the earth conductor (yellow/green) to the terminal marked with the symbol (see diagram also
available by the terminal board):
3.9 Connection to the water mains
The appliance must be supplied with softened drinking water, with hardness between 0.5°F and
5°F. and maximum temperature 30°C. It is obligatory to use a softener to reduce the formation
of limescale inside the cooking chamber. The water pressure must be between 100 and 200 kPa
(1.0 -2.0 bar). If the mains pressure exceeds 2.0 bar, install a pressure reducer upstream of the
appliance. If the value is lower than 1.0 bar use a pump to raise the pressure. The appliance is
equipped with flexible hose (1.5 metres) with threaded ¾" female fittings and relevant gaskets.
The old joints must not be used. Connection to the water mains must be performed through the
¾" threaded solenoid valve located at the rear (bottom) of the appliance (see Fig.1), interposing a
mechanical filter and a stopcock (before connecting the filter drain off a certain amount of water
to flush the pipe from any dirt).
Warning
Any damage caused by limescale or other chemicals contained in the water are not covered by
warranty.
page 12 _____________________________________________________________________________________________