Comnet netwave NW2 Installation And Operation Manual page 39

INSTALLATION AND OPERATION MANUAL
• The last screen will confirm to reboot. Hit Yes.
• Unit will reboot and the page will refresh after about 60 seconds.
• It is recommended that a factory reset be performed by hitting the Restore to Default button
at the bottom of the ADMIN page but may not be required. Consult ComNet tech support for
further detail on the particular upgrade or refer to the firmware release notes.
• End of Firmware upgrade procedure
8.7.2 ADMIN Page HOST NAME Section
Enter in the desired host name.
Remember to select Apply if any changes were made.
8.7.3 ADMIN Page ADMIN ACCOUNT Section
Administrator Username
Current Password
Remember to select Apply if any changes were made.
8.7.4 ADMIN Page READ-ONLY ACCOUNT Section
The read only account is for monitoring only with no configuration authorization
Enable Read-Only Account
Read-only Username
Password
Remember to select Apply if any changes were made.
TECH SUPPORT: 1.888.678.9427
Default is admin
Default is admin
Enabled by Default
Default is guest
Default is guest
NW1/NW2
INS_NW(1,2)_REV– 06/10/13 PAGE 39