Network Settings Page - Client Or Access Point - Comnet netwave NW2 Installation And Operation Manual
Industrial outdoor 802.11a/n wireless ethernet
Hide thumbs
Also See for netwave NW2:
- Installation and operation manual (71 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (8 pages)
Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL
8.5 NETWORK SETTINGS Page – Client or Access Point
8.5.1 NETWORK SETTINGS Page LOCAL AREA NETWORK Section
LAN Mode
IP Address
Netmask
Gateway IP
DHCP Fallback IP This will be the address the web server will default to if it cannot
DHCP Mode
DHCP Start IP
Address
TECH SUPPORT: 1.888.678.9427
Embedded web server addressing mode. Options are static or
dynamic for an address from a local DHCP server.
For setting the static address for the embedded web server.
Static network mask
Static gateway IP address
establish communications with a DHCP server
This enables an option to make the node act as a DHCP server. Note:
Can only set DHCP server if the node is statically addressed. Once the
DHCP Server option has been selected, DHCP option fields below are
enabled for entry.
DHCP address block start address
NW1/NW2
INS_NW(1,2)_REV– 06/10/13 PAGE 29
Advertisement
Table of Contents
Need help?
Do you have a question about the netwave NW2 and is the answer not in the manual?