Module Programming For Convenience Only (Skip Transponder) - Directed DIRECTWIRE DIRECTECHS 933.TL14 Installation Manual

Module programming for convenience features only (skip transponder)
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
1
equipped with a manual transmission, make sure the gearshift is in the neutral position.
Connect the 12-pin main power harness to the module.
2
DS3+: Wait until the LED turns ON solid red then proceed to the next step.
DS4+: The LED turns ON solid blue for 1 second to confirm Bluetooth communication. Wait until
the LED turns ON solid red, then proceed to the next step.
Connect remaining harnesses to the module then press the programming button five (5) times.
3
The LED turns ON solid orange.
4
Turn the ignition ON and wait until the LED turns OFF.
5
Turn ignition OFF and remove the key from the ignition barrel.
Pair remotes (if applicable).
6
For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or on
www.directechs.com. Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
13
933.TL14 1.02.198.9 2023 Toyota Camry
©2023 VOXX•DEI LLC. All rights reserved.
DS3+ DS4+
10 12 22 8
OR
Must connect 2 4 4 4 2
Solid Solid Solid
12-pin FIRST
1 Sec
Connect
remaining
Solid
Press &
harnesses
Release x5
Key IN
Off
START
Key OUT
START
AFTERMARKET
Pair
remotes*