Brother DCP-1510 Service Manual page 165

1.3.8 Chec 1.3.8 Check con
<Function> <Function>
This function is used to check that the buttons on the control panel operate normally. This function is used to check that the buttons on the control panel operate normally.
<Operating Procedure> <Operating Procedure>
(1 (1) ) Nu
(2) "00" is di (2)
(3) When butt (3)
k control p trol panel b anel button utton opera
Nume meri ric ke c key pa y pad mo d mode dels ls
Press the [1] and [3] buttons in this order in the initial state of maintenance mode. Press the [1] and [3] buttons in this order in the initial state of maintenance mode.
Non-numeric key pad models Non-numeric key pad models
Pres Pr ess th s the [ e [ ] or ] or [ [ ] bu ] butt tton t
[OK] button. [OK] button.
"00" is displaye splayed on the LCD d on the LCD. Press the b
numbers provided on the figure below. numbers provided on the figure below.
Each time the button is pressed, the corresponding number is displayed on the LCD in Each time the button is pressed, the corresponding number is displayed on the LCD in
decimal notation. Check that the number displayed on the LCD matches the number decimal notation. Check that the number displayed on the LCD matches the number
assigned to the button that has been pressed. If the buttons are pressed in the incorrect assigned to the button that has been pressed. If the buttons are pressed in the incorrect
order, "INV order, "INVALID OPERATE" is displayed on the LCD. Pr ALID OPERATE" is displayed on the LCD. Press the [Stop/Exit] button, and th
press the correct button. press the correct button.
When button operati on operation is normal, th on is normal, the machine ret
mode when the last button is pressed. To cancel the operation and return to the initial state mode when the last button is pressed. To cancel the operation and return to the initial state
of maintenance mode, press the [Stop/Exit] button. of maintenance mode, press the [Stop/Exit] button.
DCP-15** series, DCP-16** series DCP-15** series, DCP-16** series
MFC-18** series MFC-18** series
MFC-19** series MFC-19** series
4-14 4-14
operation ( tion (funct function co ion code: 13
on to di o disp spla lay "M y "MAI AINTE NTENA NANC
. Press the buttons on t uttons on the contro
e machine returns to the init urns to the initial state of ma
Fig. 4-5 Fig. 4-5
Fig. 4-6 Fig. 4-6
Fig. 4-7 Fig. 4-7
de: 13) )
NCE 13 E 13" on " on th the LC e LCD an D and pr d pres
he control panel ac l panel accordin cording to the
ess the [Stop/Exit] button, and then
ial state of maintenan
Confidential Confidential
ess th s the e
g to the
en
intenance ce