Brother DCP-1510 Service Manual page 132

Assembling Note: Assembling Note:
• • Fold the lase
Electrode plane Electrode plane
To be connected To be connected
to laser unit to laser unit
Assembling Note: Assembling Note:
• • If you replac
• • After
Fold the laser unit flat cabl r unit flat cable as shown in the figu
4 4 5 5 ° °
Mountain fold Mountain fold
Valley fold Valley fold
If you replaced the laser uni ed the laser unit, attach th
location shown in the figure below. location shown in the figure
After the the replac replacement, ement, refer refer to to "2.
enter the adjusted value of the laser unit. enter the adjusted value of the laser unit.
Serial number label Serial number label
2-44 2-44
e as shown in the figure below re below. .
Laser unit flat cable Laser unit flat cable
4 4 5 5 ° °
155 mm 155 mm
172 mm 172 mm
Fig. 2-42 Fig. 2-42
t, attach the serial num e serial number label of the la ber label of the laser unit onto th
below.
"2. IF YOU IF YOU R REPLACE THE LASER UN EPLACE THE LASER
Fig. 2-43 Fig. 2-43
Confidential Confidential
Electrode plane Electrode plane
To be connected to To be connected to
main PCB ASSY main PCB ASSY
4 4 5 5 ° °
20 mm 20 mm
ser unit onto the e
UNIT" in chapter IT" in chapter 3 3 to to