Brother DCP-1610W Quick Setup Manual

DCP‑1610W / DCP‑1615NW / DCP‑1616NW / MFC‑1910W /
MFC‑1911W / MFC‑1911NW / MFC‑1915W / MFC‑1916NW
Quick Setup Guide
Version 0
OCE/ASA/SAF/GLF/TWN
Unpack the machine and check the components
Watch our FAQ Videos for help
with setting up your Brother
machine:
solutions.brother.com/videos.
1
Remove the packing materials and install the toner cartridge
2
Load paper in the paper tray
3
Connect the power cord and turn on the machine
Back
Change your language (if needed)
5
Only for certain models
1.
(DCP models)
1. Press Menu, and then press ▲ or ▼ to choose 1.General Setup.
2. Press OK.
(MFC models) Press Menu, 0, 0, and go to step 3.
2.
Press ▲ or ▼ to choose 0.Local Language, and then press OK.
3.
Press ▲ or ▼ to select your language, and then press OK.
4.
Press Stop/Exit.
7
Connect the machine to your computer/mobile device
• Windows PC with a CD-ROM drive, go to step
®
• Windows PC without a CD-ROM drive, go to step
®
• Macintosh, go to step 7B
• Mobile device users with a WPS/AOSS
Inbox Toner Cartridge
(For MFC-1915W and
CD‑ROM
MFC-1916NW)
To use A5 Long Edge paper.
Front
7A
7B
-supported access point/router, go to step
™
Telephone Line Cord
(For MFC models)
A5 Long Edge Paper Input
Support
Select your country/language
4
(Initial setup only)
After turning on the machine, you may be required to set your
country or language (depending on your machine).
If required, follow the on-screen instructions.
6
Connect the telephone line cord (for MFC models only)
(MFC-1915W / MFC-1916NW)
7C
Not all models are available in all countries.
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Read the Product Safety Guide first, then read this Quick Setup Guide for the
correct installation procedure.
NOTE:
• The components included in the box and the AC power plug may differ
depending on your country.
• The illustrations in this Quick Setup Guide are based on the MFC-1910W.
• You must purchase the correct interface cable for the interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T
or 100BASE-TX Fast Ethernet Network.
Adjust the paper guides to fit
the paper being used.
(MFC-1910W / MFC-1911W /
MFC-1911NW)