Brother DCP-1510 Service Manual page 116

7. 7.6 6 Low v Lo
Note: Note:
• • Do not pull
(1) Remov (1)
Taptite cup S M3x8 SR Taptite cup S M3x8 SR
w vol olt t ag age p e pow ower er su supp
Do not pull out the low volt out the low voltage PCB harness forcefully
the high voltage power supply PCB ASSY the high voltage power supply
ASSY first to avoid it getting damaged. ASSY first to avoid it getting damaged.
Remove the four t e the four taptite b aptite bind B M4x1
the screw pan (S/P washer) M3.5x6 screw to remove the low voltage shield plate and the the screw pan (S/P washer) M3.5x6 screw to remove the low voltage shield plate and the
low voltage PCB insulation sheet. low voltage PCB insulation sheet.
Assembling Note: Assembling Note:
• • Make sure to attac Make sure to attach insulati h insulation sheet. Failu
in fire or electrical shock. in fire or electrical shock.
High voltage power High voltage power
supply PCB ASSY supply PCB ASSY
Low voltage shield plate Low voltage shield plate
Taptite bind B M4x12 Taptite bind B M4x12
2-28 2-28
pply ly PC PCB u B uni nit t
age PCB harness forcefully, to avoid it
PCB ASSY. Remove the high voltage power . Remove the high voltage power supply PCB
ind B M4x12 screws 2 screws, the two t , the two taptite c
on sheet. Failure to attach the insul re to attach the insulation sheet can resu
Screw pan (S/P washer) M3.5x6 Screw pan (S/P washer) M3.5x6
Fig. 2-23 Fig. 2-23
, to avoid it coming into cont coming into contact with
supply PCB
aptite cup S M3x8 SR s up S M3x8 SR screws, a
ation sheet can result lt
Low voltage PCB Low voltage PCB
insulation sheet insulation sheet
Taptite cup S M3x8 SR Taptite cup S M3x8 SR
Confidential Confidential
act with
crews, and nd