D077 - Check Tool Clamping Sets Of The Milling Spindles - Index G200.3 Operating Instructions Manual

Maintenance Summary - 4.000 Operating hours
D077 - Check tool clamping sets of the milling spindles
Orientation
Maintenance Instructions
G200.3 G220.3
DIE248EN - 15.08.2022
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Due to different requirements and/or specifications of the respective
manufacturers, be sure to review the respective manufacturer's
documentation!
The clamping sets (HSK and Capto) installed in the tool or milling spindles should
be checked regularly. Regular checks ensure continuous and trouble-free operation.
Based on manufacturer's instructions, we recommend replacement of the clamping
sets when the clamping force falls below the following values (see Table F
Table for testing the clamping force of clamping systems
F = nominal clamping force in kN (manufacturer data)
1
F = manufacturer recommendation in kN
min
The values for F listed in the table are based on DIN 69063-1 for HSK and ISO
1
26623-2 for PSC - CAPTO
) .
min
105