Index G200.3 Operating Instructions Manual page 149

Maintenance Summary - 8 Years
Requirement
Maintenance Instructions
G200.3 G220.3
DIE248EN - 15.08.2022
If sealing compounds from other manufacturers are used, their
equivalence must be guaranteed by the supplier or manufacturer in
writing.
When mounting and dismounting the front cover/design pane using a
crane, INDEX recommends using suitable suction lifters to secure it.
To ensure safe handling, both the suction surfaces of the suction
lifters used and the corresponding areas of the design pane must be
carefully cleaned beforehand.
Personal protective equipment -> Use gloves with rubberized palm/
inside.
Determine and prepare the storage location for the design pane. To
prevent scratching of the design pane, cover the surface at the
storage location with suitable tarpaulins, foils, felt mats or similar.
Under certain circumstances, the design pane can also remain on the
crane near the ground. Shut down and secure the crane and seal off
or secure the surrounding area.
Example: Bohle suction lifter (max. 60 kg and max.100 kg)
Before disassembling the design pane, observe the following:
1. It may be necessary to remove a door handle (depending on the
machine type).
2. Install the eyebolts (X). (included with the delivery)
3. Design pane using round slings (as in 1 and 2 in the example:
Transport design element G420 as described) and lift slightly
with a crane. In the case of the variant shown in example 2, it is
essential to secure the round slings in such a way that they
cannot slip.
4. It is essential to ensure that the slinging angle of the slinging
ropes/round slings does not fall below an angle of 60° in order
to prevent diagonal pull and the associated damage to the
design pane.
143