Table of Contents
Advertisement
Available languages
Available languages
1.
Programable Output
receptacles: connect to non-
critical mission loads (max 10A)
2.
General Output receptacles:
connect to critical mission
loads (max 10A)
3.
AC input
4.
Network/Fax/Modem surge
Important Safety Warnings
3
Please comply with all warnings and operating instructions in this manual
strictly. Save this manual properly and carefully read the following
instructions before installing the unit. Do not operate this unit before
reading through all safety information and operating instructions carefully:
Transportation
•
Please transport the UPS system only in the original package to
protect against shock and impact.
Preparation
•
Condensation may occur if the UPS system is moved directly from
cold to warm environment. The UPS system must be absolutely dry
before being installed. Please allow at least two hours for the UPS
system to acclimate to the environment.
•
Do not install the UPS system near water or in moist environments.
•
Do not install the UPS system where it would be exposed to direct
sunlight or near heat sources.
•
Do not block ventilation holes in the UPS housing.
Installation
•
Do not connect appliances or devices which would overload the UPS
system (e.g. laser printers) to the UPS output sockets.
•
Place cables in such a way that no one can step on or trip over them.
•
Do not connect domestic appliances such as hair dryers to UPS
output sockets.
protection
5.
USB communication port
6.
RS-232 communication port
7.
SNMP intelligent slot
8.
Emergency power off function
connector (EPO)
9.
Connector for battery pack
05
Advertisement
Table of Contents
