Njoy UPCMCOP130HBAAZ01B User Manual page 24

14: Charger Boost voltage setting
Cbu 236
15: Charger Float voltage setting
CFu 228
16: EPO logic setting
EPO AO
24
Battery capacity(AH)
NOTE:
If you connect Battery Pack 2U for
Balder 1500 to Balder 1500 you should set
maximum charger current to 4A.
If you connect Battery Pack 2U for Balder
3000 to Balder 3000 you should set maximum
charger current to 4A.
Parameter 2: Set up the charger boost
voltage.
2.25-2.40: setting the charger boost voltage
Vdc
from 2.25 V/cell to 2.40V/cell. (Default:
2.36V/cell)
Parameter 2: Set up the charger float
voltage.
2.20-2.33: setting the charger float voltage
from 2.20 V/cell to 2.33V/cell. (Default:
Vdc
2.28V/cell)
NOTE:
Parameters 14 and 15 should be set
based on batteries specifications.
Parameter 2: Set up the EPO function
control logic.
AO: Active Open (Default). When AO is
selected as EPO logic, it will activate EPO
function with Pin 1 and Pin 2 in open status.
AC: Active Close. When AC is selected as
EPO logic, it will activate EPO function with
Pin 1 and Pin 2 in close status.
7~20
20~40
40~60
60~80
80~100
100~150
Total charging
current (A)
2
4
6
8
10
12