Njoy UPCMCOP130HBAAZ01B User Manual page 12

Step 4. UPS input connection: Plug the UPS into a two-pole, three-wire,
grounded receptacle only. Avoid using extension cords.
Step 5. UPS output connection: For socket-type outputs there two kinds
of output: programmable outlets and general outlets. Please connect non-
critical devices to the programmable outlets and critical devices to the
general outlets. During power failure, you may extend the backup time
to critical devices by setting shorter backup time for non critical devices.
CAUTION
Do NOT plug LASER
PRINTERS into any of
the outlets.
Step 6. Communication connection: To allow for unattended UPS
shutdown/start-up and status monitoring, connect the communication
cable one end to the USB/RS-232 port and the other to the communication
port of your PC. With the monitoring software installed, you can schedule
UPS shutdown/start-up and monitor UPS status through PC. The UPS is
equipped with a slot for either SNMP or AS400 card. When installing either
SNMP or AS400 card in the UPS, it will provide advanced communication
and monitoring options.
USB Port
NOTE!
USB port and RS-232 port can't work at the same time.
12
Communication port:
RS-232 Port
Do NOT plug any SURGE
STRIPS into any of the
outlets.
Intelligent slot