Njoy UPCMCOP130HBAAZ01B User Manual page 13

Step 7. Network connection: Connect a single modem/phone/fax line
into surge-protected "IN" outlet on the back panel of the UPS unit.
Connect from "OUT" outlet to the equipment with another modem/fax/
phone line cable.
Step 8. Disable and enable EPO function: Keep the pin 1 and pin 2 closed
for UPS normal operation.
It's in closed status for UPS
normal operation.
Step 9. Turn on the UPS: Press the ON/Mute button on the front panel
for two seconds to power on the UPS.
NOTE!
The battery charges fully during the first five hours of normal operation. Do
not expect full battery run capability during this initial charge period.
Step 10. Install software: For optimal computer system protection, install
UPS monitoring software to fully configure UPS shutdown. Use supplied
RS-232 or USB communication cable to connect RS-232/USB port of
UPS and RS-232/USB port of PC. Install the UPS monitoring software
from https://www.power-software-download.com/viewpower.html
configure UPS shutdown.
Network/Fax/Phone surge port:
To activate EPO
function, remove
these two screws.
to fully
13