HTP Revolution 2500 Manual page 28

It works like in MIG 2T.
Pressing again the button
regulate the "Hot Start".
It is possible adjust the "Hot start" value from
50 – 200 % of your wire speed .
For example if the main welding parameter is
10 m/min when you press and keep pressed
the torch button the initial welding parameter
will be at 13 m/min .
Note: If wire feed speeds selected here are
producing Amperages over 220 amps, the
machine will automatically limit the output
accordingly
Pressing again the button
regulate the Slope Down Time t2.
it is possible
it is possible
It is possible adjust the t2 value from 0,1 to 10
seconds.
Pressing again the button
regulate the Slope Down Time t3.
It is possible adjust the t2 value from 0,1 to 10
seconds.
Pressing again the button
to regulate the FINAL CURRENT, that is a
value used to fill the crater when welding
aluminum. A good starting point for the user
here is 60%
It is possible adjust the t2 value from 0,1 to 10
seconds.
Pressing again the button
regulate the Burn Back Value.
It works like in MIG 2T/4T.
it is possible
it is possible
it is possible