Table of Contents
Advertisement
WARNING:
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„
„
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
„
„
specifications might exceed the supported output of your receiver (5 V/500 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
It is advised not to store important information on USB storage devices used with the receiver.
„
„
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
„
„
device via your receiver. Formatting requires entering the PIN code (default 1234)
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
„
„
file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 PIN-CODE DEFAULT: 1234
2.2 Front Panel
1. Mode indicator:
2. IR sensor:
3. USB:
2.3 Rear Panel
1. RF IN
2. S/PDIF Coaxial
3. HDMI
4. LAN
5. TV SCART
6. Power Cord
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used, we recommend
using (e.g. NiMH) types with low self-discharge to ensure long time
operation of remote control.
RED indicates that the receiver is in STAND-BY mode.
GREEN indicates that the receiver is in OPERATING mode.
Point your remote control towards this sensor.
Connector for USB devices.
To connect to your antenna for the reception of broadcast signal.
To connect your receiver to a digital audio amplifier.
To connect your receiver with your TV set using a HDMI cable.
To connect your receiver to Ethernet LAN
To connect your receiver with your TV set using a SCART cable.
Your receiver requires a voltage of 220~240 V AC (Auto-
selectable), 50/60 Hz +/-5%. Check the local power specification
before connecting your receiver to the wall outlet.
Fig. 1
Fig. 2
5
Advertisement
Table of Contents
