Configuring The Sip Paging 25V/70V Amplifier; Gather The Required Configuration Information; Static Or Dhcp Addressing; Username And Password For Configuration Gui - CyberData 011579 Operation Manual

2.6 Configuring the SIP Paging 25V/70V Amplifier

Use this section to configure the SIP Paging 25V/70V Amplifier.

2.6.1 Gather the Required Configuration Information

Have the following information available before you configure the SIP Paging 25V/70V Amplifier.

2.6.1.1 Static or DHCP Addressing?

Know whether your system uses static or dynamic (DHCP) IP addressing. If it uses static
addressing, you also need to know the values to assign to the following SIP Paging 25V/70V
Amplifier parameters:
•
•
•

2.6.1.2 Username and Password for Configuration GUI

Determine the Username and Password that will replace the defaults after you initially log in to the
configuration GUI.
•
•

2.6.1.3 SIP Settings

To configure the SIP parameters, determine whether you want to register with the server. If you do,
determine the number of minutes the registration lease remains valid, and whether you want to
automatically unregister when you reboot. To configure the SIP parameters, you also need to
determine the values for these parameters:
•
•
•
CyberData Corporation
IP Address
Subnet Mask
Default Gateway
The Username is case-sensitive, and must be from four to 25 alphanumeric characters long.
The Password is case-sensitive, and must be from four to 20 alphanumeric characters long.
SIP Server IP Address
Remote and Local SIP Port Numbers
SIP User ID, and Authenticate ID and Password for this User ID
Gather the Required Configuration Information
931996A
Setting Up the SIP Paging 25V/70V Amplifier
Operations Guide
15