Pre-Operational Checklist; Break In - H&S 2957 Operator's Manual

4.2 Pre-Operational Checklist

1. Lubricate the machine following the schedule outlined in section 5.
2. Only use a tractor with adequate power to operate machine (see section 7).
3. Ensure that the machine is properly attached to the tractor. Be sure that a retainer is installed in the
drawbar pin and the safety chain is attached.
4. Inspect the hydraulic system. Ensure that the hydraulic reservoir on the tractor is filled to required
specifications.
5. Inspect all hydraulic lines, hoses, and fittings. Clean fittings with a clean rag before connecting to
the tractor.
6. Check the tires to be sure they are inflated to the specified pressure.
7. Check the cradle and tilt system. Be sure it can move freely. Remove any entangled material.
8. Check that the rotor turns easily and that the flails swing freely. Remove all twine, wrap, and other
materials that may be entangled.
9. Check that the PTO driveline is connected to the tractor PTO output shaft.
10. Close and secure all guards.
4.3 Break-In
Although there are no operational restrictions on the Bale Processor when used for the first time, it is
recommended that the following mechanical items be checked.
A. Before First Start Up:
1. Attach the Bale Processor to the tractor.
2. Cycle the lift frame and the bale cradle several times to fully charge the hydraulic cylinders with oil.
3. Top up the tractor oil reservoir if required.
4. Check the gearbox for any signs of leakage and check the gearbox oil level (Should be visible at the
top of the oil plug).
B. After operating for 1/2 hour:
1. Re-torque all wheel bolts.
2. Re-torque all other fasteners and hardware.
3. Disconnect the PTO driveline and turn the rotor by hand. Be sure that it turns freely.
4. Check the rotor and flails. Remove all entangled material.
5. Check that no hoses are pinched, rubbing, bent, or crimped. Re-align as required.
6. Check for oil leaks. Repair or stop any leaks before continuing.
7. Lubricate all grease fittings.
8. Check gearbox for signs of leakage or wear.
C. After operating for 5 hours and 10 hours:
1. Re-torque all wheel bolts, fasteners, and hardware.
2. Check hydraulic hose routing.
3. Check that rotor turns freely.
4. Check that all flails move freely. Remove all entangled material.
5. Check the gearbox for signs of leakage or wear.
6. Follow the normal servicing and maintenance schedule as defined in section 5.
- 4.2 -