H&S 2957 Operator's Manual page 46

9 PDI (Setup)
As part of the shipping process, your Bale Processor (If equipped with a hydraulic
deflector kit) will require some setup. Please follow the steps below to get your
Bale Processor set up for use.
1. Remove cylinder mounting pin from the
deflector lock plate by removing the 3/8" bolt/nut.
DO NOT DISCARD.
2. Remove the Cylinder Mounting Pin.
3. Remove and discard the 5/8" bolt holding the
deflector shield in the vertical position.
- 9.1 -