Transporting - H&S 2957 Operator's Manual

4.8 Transporting

1. Be sure that the unit is hitched positively to the towing vehicle. Always use a
retainer in the drawbar pin and a safety chain between the machine and the tow
vehicle.
NOTE: Use two safety chains when using a truck to transport the processor and
cross them under the hitch when connecting (As shown in picture below).
2. Install lift frame lock pin before transporting.
3. If transporting with a tractor, install an SMV emblem in the location provided.
4. Always use hazard warning flashers on the tractor when transporting unless
prohibited by law.
5. Do not exceed 20 mph (32 kph). Reduce speed on rough roads and surfaces.
6. Keep to the right and yield the right-of-way to allow faster traffic to pass.
7. Make sure the SMV (Slow Moving Vehicle) emblem and all the lights and
reflectors that are required by the local highway and transportation authorities
are in place, are clean and can be seen clearly by all overtaking and oncoming
traffic.
8. Make sure you are in compliance with all local regulations regarding
transporting equipment on public roads and highways.
- 4.13 -