H&S 2957 Operator's Manual page 44

8.1 Hydraulic Deflector Kit Installation
1) Install the deflector kit cylinder mount into the
slotted holes on the shroud.
2) Use the provided 3/8" bolts, nuts, and washers
to secure the mount to the shroud. Tighten the
bolts with the cylinder mount pushed up as high
as the slotted holes will allow.
Note: To prevent damage it is important
the mount sit as high as possible.
3) Install the cylinder into the cylinder mount,
secure with the mounting pin (3-11/16"), 3/8"
bolt, flat washer, and lock nut.
- 8.1 -