Table of Contents
Advertisement
fig. B.1 Mainboard lay out with 2 POC modules
B.3
INSTALLATION
A POC / RS232-C module can be placed on each channel.
On channel 2 the POC module can be used for both POC and digital output
On channel 1 it only can add digital output
When the option is factory installed the on/off function is built in the right-hand side control panel for
channel 2. When the POC module is purchased later, the switch can be mounted by a qualified service
engineer. Then the option has to be ordered with "retrofit switch for BD 12 / 12E"
When a pen offset compensation module is not mounted yet, proceed as follows:
*)
When optional remote control is mounted.
1) Switch off the recorder
2) Refer to section B3.1 of this manual for opening the case and remove the jumper from the two-pin
header next to the female socket (only channel 2)
3) Set the switch on the module for channel 1 to "0" or "8" and the switch for channel 2 to "1" or "9" see
fig. B.2 on the next page.
4) Attach the POC module(s) onto the socket, see fig. B.1. (fig B.1 shows the locations of the modules
on the main board)
5) when necessary mount the POC switch plus components
6) Close the case.
28
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
*)
.
Kipp & Zonen B.V.
*)
.
Advertisement
Table of Contents
