Table of Contents
Advertisement
fig. B.5 location of the POC switch
When the changes have been made, you can replace the top cover by placing it over the bottom part and
bringing it precisely into position. When this is done accurately enough, hardly any force is needed. As
soon as the top cover is correctly in place, the housing can be closed again by pinching softly the top and
bottom part of the cover together at each of the corners. Soft clicks will confirm your proper handling.
B.3.3
Removing the POC module
When the POC module for channel 2 is to be removed the same actions has to be performed as
described in section B3.1. for opening the housing. Remember that the jumper has to be replaced as
indicated in figure B.1 The POC module for channel 1 has no jumper.
The POC switch mounted on the right hand panel can remain there although it has no function.
B.4
OPERATION
When the modules are installed into the recorder and the case is closed switch the power on. To
facilitate zero adjustment for each pen, the pen-offset compensation is automatically switched-off when
the zero switch of the input module is set to zero. When turning the switch from zero, the pen of channel
2 will start tracking his input signal after a delay that is needed to compensate for the distance between
the pens.
When the POC module is factory installed the POC can be switched on and off by means of the POC
switch on the right-hand control panel.
Switching off the Pen Offset Compensation of channel 2, can also be accomplished by pulling pin 5 of the
15 pins sub D low (Connecting pins 5 and 15 from the optional remote control connector).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
Kipp & Zonen B.V.
31
Advertisement
Table of Contents
