Table of Contents
Advertisement
Applying the opening force between the top and bottom cover could of course also be done by means of
a screwdriver, but it is very likely that the recorder housing would be damaged that way.
After that, repeat the same action for the three ridges at the front side. These three ridges can easily be
bent forward by hand, so no screwdriver is needed here. When this has been done, put back the
recorder upright again. You must do this, however, without applying too much "closing force", otherwise
you have to repeat the steps, described before.
fig. B.4 Opening the recorder housing
Once it is upright again, you can easily remove the top cover. It remains connected to the inside of the
recorder however, because the top cover holds the input connectors. The connecting wires are just long
enough to let the top cover rest at the table upside down behind the bottom part of the recorder housing.
B.3.2
Mounting the POC switch
The POC switch plus two additional components have to be soldered on the servo control board as
indicated in fig B.5
The cover plate is already prepared for this switch only the white square where the knob will come has to
be pressed out.
Make sure that the knob is mounted in the same way as the other switches, with the lower side facing the
front.
30
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
Kipp & Zonen B.V.
Advertisement
Table of Contents
