3.2.5 Polarity selection
If desired, the polarity of each of the channel inputs can be inverted independently. The selection is
performed by setting the involved switches, which are located at the rear side of the recorder. The
location of these switches is indicated in figure 1 in chapter 3 PREPARATIONS FOR USE. They can only
be accessed after the paper roll has been taken out, as described in section 3.2.2 Changing paper.
The factory default setting of these switches is "left". If one of these switches is set to "right", the
corresponding channel will have it zero position at the right hand side.
NOTE:
Inverting the input polarity does not result in a displacement of
the zero position but in a mirrored channel performance.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
Kipp & Zonen B.V.
15