Table of Contents
Advertisement
Before switching on the recorder, make sure that the required fuses are installed. Operating the recorder
at 115 V requires 250 mA fuses, while an operation voltage of 230 V requires 125 mA fuses. The mains
on/off switch is located on the left-hand side of the recorder. Make sure that only fuses of the required
current rating and type are used for renewal. The use of repaired fuses, and/or the short-circuiting of fuse
holders, is prohibited.
Fuses should only be renewed by a qualified person, who is aware of the hazards involved.
NOTE :
If the mains plug has to be adapted to the local situation, it
should only be done by a qualified person.
WARNING:
The instrument shall be disconnected from all sources
when a fuse is to be renewed, or when the instrument is to
be adapted to a different mains voltage.
fig. 1 Rear side of the recorder
3.2.2 Changing paper
First lift the plastic transparent ruler off the paper (see fig. 2), turn it all the way to the top of the recorder
and leave it in that position. In order to do so easily, place the fingers of both hands on top of the recorder
housing and with both thumbs apply a gentle force to the respective ends of the ruler pointing upward and
a little backward, for which purpose the ruler is equipped with small ridges. Figure 2 shows the lifting of
the ruler.
12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
Kipp & Zonen B.V.
Advertisement
Table of Contents
